Reisser R2 BZP Countersunk Wood Screws (Bright Zinc Plated)

Reisser R2 BZP wood screws (Bright Zinc Plated, also known as zinc plated wood screws) are a dependable, trade-friendly choice for everyday timber fixing in dry, internal environments.

The Reisser R2 range is built for fast, clean fixing into softwood and sheet materials, making it a great option for joinery, studwork, carcassing, battens and general site work where you want a tidy finish and consistent drive.

Why choose Reisser R2 BZP wood screws

  • BZP (bright zinc plated) finish for a clean silver look and general indoor corrosion resistance
  • Made for timber fixing across common building and joinery tasks
  • Trade-standard choice when you want good value and reliable performance indoors.

When to choose something else

For outdoor jobs, damp areas, treated timber, or coastal environments, you’ll generally want stainless steel or a heavier-duty coated/galvanised option rather than standard BZP.

Reisser R2 Woodscrews (Countersunk Zinc / BZP) FAQs

What are Reisser R2 Countersunk Zinc screws?

They’re Reisser R2 wood screws with a countersunk head and a Bright Zinc Plated (BZP) finish. Reisser describe them as being made to the same spec as their R2 YZP screws, but with a different (bright zinc) appearance.

Are these “BZP” or “zinc plated” screws?

Both. BZP is short for Bright Zinc Plated, which is a type of zinc plating. For UK buyers, it’s worth using both terms in your copy.

Do I need to drill a pilot hole?

Reisser state the 25° needle point is designed to penetrate almost all timbers without a pilot hole. In harder timbers, near edges, or where you want to minimise splitting, a pilot hole can still be a good idea.

What drive bit do I need?

These are Pozi drive (deep reinforced recess). Use the correct Pozi bit size for the screw you’re driving to reduce cam-out and damage to the recess.

What does “countersunk” mean on these screws?

A countersunk head is designed to sit flush (or just below the surface) when driven into timber.

What’s special about the R2 thread?

Reisser describe a sharp, wide, deep thread and their tried-and-tested R2 thread pattern, aimed at strong holding power (high pull-out resistance) across timber and board materials.

Do they drive in easily?

Reisser state the thread lubrication delivers up to 40% less driving resistance, helping with easier driving and penetration.

What materials are they intended for?

Reisser position them for timbers and board materials, and show common use cases like all woods, hard wood, board materials, and plywood.

Are they strong enough for site work?

These screws are made from specially hardened steel for high tensile and torsional strength, and that the Pozi recess helps reduce cam-out at higher torque.

Can I use BZP (bright zinc plated) screws outdoors?

BZP gives a basic/moderate level of corrosion resistance, but it’s generally not the best choice for consistently damp or outdoor exposure. For exterior work, stainless or heavier-duty coated options are usually the safer bet.

What does “full thread” vs “part thread” mean (and which should I choose)?

  • Part thread is handy when you want the screw to pull two timbers tight together (clamping action).
  • Full thread is often chosen for fixing into a single piece, thinner materials, or where you want thread engagement along the full length.